Setting The Function Table - A&D GF-30K Instruction Manual

" " indicates that memory is full or the memory capacity has been reached. More data can
fUl
not be stored unless the memory data is deleted.
Automatic self calibration can not be used while the interval memory mode is active.
The following commands can not be used during data storage.
Query command for weighing data.
Q
Query command for stable weighing data.
S
Query command for weighing data.
SI
Query command for continuous weighing data.
SIR

Setting the function table

Parameter settings for each output mode are as follows:
Mode
Key mode
Auto print mode A
Auto print mode B
Interval memory mode
Set each item for GX-K series, depending on the situation, as follows:
Data number
ID number
When 5-td 1, 2 or 3 is selected, the amount of data to be stored is 100 sets.
Set each item for GF-K series, depending on the situation, as follows:
Data number
ID number
GF-K series does not use time and date.
Enabling the data memory function
Step 1 Press and hold the
Step 2 Press the
Step 3 Press the
Step 4 Press the
Step 5 Press the
Step 6 Press the
Step 7 Press the
Item Data output
mode
prt 0
prt 1
prt 2
prt 3
d-no 0
No
d-no 1
Yes
5-id 0
No
5-id 1
Yes
d-no 0
No
d-no 1
Yes
5-id 0
No
Yes 5-id 1
SAMPLE
key several times to display
SAMPLE
key.
PRINT
key three times to display
SAMPLE
key to display
RE-ZERO
key to store the setting.
PRINT
key to return to the weighing mode.
CAL
Auto print polarity,
difference
Not used
ap-a 0-2
ap-b 0-2
Not used
Time and date
key until is displayed, then release the key.
ba5fnc
data 0
.
data 2
58
Data memory
function
data 2
data 2 Not used
data 2
data 2 int 0-8
5-td 0
No
5-td 1
Time only
5-td 2
Date only
5-td 3
Both
.
dout
.
Interval time