Data Memory For Tare Value - A&D GF-30K Instruction Manual

12-6. Data Memory for Tare Value

The data memory function can store 20 sets of tare values for weighing.
The tare value in memory can be recalled easily using the
The tare value in memory can be recalled and changed.
Notes
The recalled tare value can be changed, using the digital input mode or the weighing
input mode. The digital input mode enters the tare value using the keys. The
weighing input mode uses a sample tare container to store the tare value.
The NET indicator illuminates during tare operation.
12-6-1. Storing the tare value
To store a new tare value: Recall the stored tare value to be changed ("
change the recalled tare value using the digital input mode or the weighing input mode, and
store the new value.
Notes
The recalled tare value can be changed, using the digital input mode or the
weighing input mode. The digital input mode enters the tare value using the keys.
The weighing input mode uses a sample tare container to store the tare value.
The NET indicator illuminates during tare operation.
When the
RE-ZERO
is displayed, The NET indicator does not illuminate.
t--
" " appears when a tare operation is performed without using the tare value
stored in memory.
While the data memory function is in use, unit selection using the
not available.
Clr
If " " appears blinking in the upper left of the display, delete the data in memory.
Refer to "12-1. Notes on Using Data Memory".
Step 1 Press the
Step 2 Set the "Data memory (
Step 3 Press and hold the
enters the tare value confirmation mode. The tare
value last selected is displayed.
Step 4 Select the tare number to be used, using the following keys.
RE-ZERO
key ......... To decrease the tare number by one.
MODE
key ............ To cancel it and to return to the weighing mode.
CAL
Each time the
changes as follows: ↔
Step 5 To change the selected tare value:
To use the weighing input mode, press the
mode. Go to "Weighing input mode" on the next page.
To use the digital input mode, press the
key to enter the digital input mode. Go to "Digital input mode" on the next page.
key is pressed with nothing placed on the weighing pan, zero
key to select a unit to be used for storage.
MODE
)" parameter to "
data
key until the balance
PRINT
key ..... To increase the tare number by one.
key or
RE-ZERO
↔
t03
MODE
".
5
key is pressed, the displayed value
MODE
↔ ........ ↔
↔
t04 t20
SAMPLE
key, then press and hold the
SAMPLE
67
key and used for weighing.
" to "
t01 t20
MODE
No.3, Tare number
↔
t01
key to enter the weighing input
"). Then,
key is
Tare
MODE