Data Memory For Comparator Settings - A&D GF-30K Instruction Manual

12-5. Data Memory for Comparator Settings

The data memory function can store 20 sets of upper and lower limit values for the
comparator mode. The reference value or tolerance value for the comparator mode can not
be stored in memory.
The upper and lower limit values in memory can be recalled easily using the
and used for weighing.
The upper and lower limit values in memory can be recalled and changed.
Note
The recalled upper and lower limit values can be changed, using the digital input
mode or the weighing input mode. The digital input mode enters the upper and lower
limit values using the keys. The weighing input mode uses a sample to store the
upper and lower limit values.
12-5-1. Storing the upper and lower limit values
To store new upper and lower limit values: Recall the stored upper and lower limit values to
be changed ("
C01
the digital input mode or the weighing input mode, and store the new value.
Note
While the data memory function is in use, unit selection using the
not available.
Clr
If " " appears blinking in the upper left of the display, delete the data in memory.
Refer to "12-1. Notes on Using Data Memory".
Step 1 Press the
used for storage.
Step 2 Set the "Data memory (
Step 3 Press and hold the
balance enters the upper and lower limit
values confirmation mode. The upper limit
value last selected is displayed.
Step 4 Select the comparator number to be used, using the following keys.
RE-ZERO
key ......... To decrease the comparator number by one.
MODE
Each time the
changes as follows: ↔
Step 5 To change the selected upper and lower limit values:
To use the digital input mode, press the
Go to "Digital input mode" on the next page.
To use the weighing input mode, press the
key to enter the weighing input mode. Go to "Weighing input mode" on the
MODE
next page.
" to " ") . Then, change the recalled upper and lower limit values using
C20
key to select a unit to be
MODE
)" parameter to "
data
PRINT
key ..... To increase the comparator number by one.
key or
RE-ZERO
C03
".
4
key until the
key is pressed, the displayed value
MODE
↔ ↔
C03
HI LO
key to enter the digital input mode.
SAMPLE
SAMPLE
64
MODE
No.3. Comparator number
Upper limit value
↔
C04 C04
HI LO
key, then press and hold the
key
MODE
key is
↔