Display Symbols And Key Operation - A&D GF-30K Instruction Manual

4. Display Symbols and Key Operation

Key Operations
Key operation affects how the balance functions. The basic key operations are:
"Press and release the key immediately" or "Press the key" are normal operation.
= normal key operation during measurement
"Press and hold the key".
Display
NET indicator
Processing indicator
Stabilization indicator
Standby indicator
of power supply
The current data number
Processing indicator
Prior notice indicator
of automatic self
calibration
Each key, when pressed or when pressed and held, functions as follows:
Key When pressed and released
Turns the display ON and OFF. The standby indicator is displayed when the display
is turned off. The weighing mode is enabled when the display is turned on. This key
is available anytime. Pressing the key during operation will interrupt the operation
and turn the display OFF.
In the weighing mode, turns the
minimum weighing value ON and OFF.
In the counting or percent mode, enters
the sampling mode.
Switches the preset weighing units
stored in the function table. Refer to "5
Weighing Units".
Performs calibration using the internal
mass for GX-K series.
Stores the weighing data in memory or
outputs to a printer or personal computer
depending on the function table settings.
(Factory setting = output)
Sets the display to zero.
Displays memory data information
Displays the weighing data relative to the weighing capacity
in percentage, in weighing mode. (Capacity indicator)
Weighing speed indicator (Response indicator)
Blinking indicators
Enters the function table mode.
Refer to "10. Function Table".
Performs weighing speed adjustment
(response adjustment) and self check.
Displays other items of the calibration
menu.
No function at the factory setting.
By changing the function table:
10
Animal mode indicator
Comparator indicators
Interval memory
Standby indicator
Weighing data or
stored data
Interval memory,
active indicator
When pressed and held
Outputs "Title block" and "End block"
for GLP report.
Displays the data memory menu.
Units