Snmp Settings Window - Cisco 4300 User Manual

Chapter 3 Configuring and Managing the IP Camera

SNMP Settings Window

The SNMP Settings window provides options for configuring Simple Network Management Protocol
(SNMP) settings for the IP camera. These settings can help you manage complex networks by sending
messages to different devices on the network.
To display the SNMP window, access the configuration windows as described in the
Initial Setup of the IP Camera" section on page
If you change any options in this window, you must click the Save Settings button to save the changes.
If you do not click this button, changes are not retained when you exit the window. Save Settings
appears at the bottom of the window. You may need to scroll down to it.
Table 3-13
Table 3-13
Option
SNMP v2c Area
Enable SNMP v2c
Read Community String Enter the SNMP read community string, which identifies the valid read
Trap Community String Enter the SNMP trap community string.
Primary Trap Receiver
Secondary Trap
Receiver
SNMP v3 Area
Enable SNMP v3
Use Default Local
Engine ID
OL-19609-04
describes the options in the SNMP Settings window.
SNMP Settings Window Options
Description
Check this check box to enable SNMP v2c.
community.
Identify the primary trap receiver of the SNMP v2c manager by choosing IP
Address or Hostname from the drop-down list and entering the IP address
or host name in the corresponding field.
Identify an optional secondary trap receiver of the SNMP v2c manager by
choosing IP Address or Hostname from the drop-down list and entering the
IP address or host name in the corresponding field.
Check this check box to enable SNMP v3.
Click this radio button if you want to use the default local engine ID for
SNMP.
The default local engine ID is 8000000903<MAC>, where <MAC> is the
MAC address of the IP camera.
Cisco Video Surveillance 4300 and 4500 High-Definition IP Cameras User Guide
2-5, click Network Setup, then click SNMP.
Network Setup Windows
"Performing the
3-21