Chapter 2 Getting Started; Installing The Ip Camera - Cisco 4300 User Manual

Installing the IP Camera

The power supply must be placed indoors. Statement 331
Warning
Note
This product must be connected to a power-over-ethernet (PoE) IEEE 802.3af compliant power source
Warning
or an IEC60950 compliant limited power source. Statement 353
Inline power circuits provide current through the communication cable. Use the Cisco provided cable or
Caution
a minimum 24AWG communication cable.
Note The power adapter that you use with the IP camera must provide power that is within +/–10% of the
required power.
The equipment is to be connected to a Listed class 2, limited power source.
Note
To install the IP camera, follow the steps in
the steps refer to, see the
.
Table 2-1 Installing the IP Camera
Action
Step 1 Attach a lens to the lens opening on the IP camera.
Step 2
If you are using a DC auto iris lens, connect its cable to
the DC auto iris lens connector on the IP camera.
Cisco Video Surveillance 4300 and 4500 High-Definition IP Cameras User Guide
2-2
If you use the IP camera outdoors, place the camera and the power supply in a suitable NEMA
enclosure.
"IP Camera Physical Details" section on page
Table 2-1. For illustrations of the connectors and ports that
Explanation
If you are using a CS mount lens, screw the lens into
•
the lens opening. The IP camera accepts CS-mount
lenses with a lens protrusion of up to 5 mm.
If you are using a C mount lens, screw the C mount
•
lens adapter that is supplied with the IP camera into
the lens opening, then screw the lens into the adapter.
Ensure that the lens is clean because any dirt may degrade
the quality of video images.
Note Save the lens opening dust cap and replace the dust
cap if you remove the lens.
For best performance, Cisco recommends that you use a
DC auto iris lens.
Chapter 2 Getting Started
1-2.
OL-19609-04