Cisco 4300 User Manual page 62

Log Windows
Table 3-25 Log Messages
Message Name
DEFAULTS_RESTORED
DEVICE_REBOOT_AUTO
DEVICE_REBOOT_MANUAL
DHCP_LEASE
DSP_ENCODING_HALTED
EMAIL_TRIGGERED
ETH_BER
ETH_SIGNAL_DEGRADE
FRAMES_DROPPED
FW_UPGRADE_FAILED
FW_UPGRADED
HTTP_TRIGGERED
INPUT_ONE_CHANGED
INPUT_ONE_RESET
INPUT_TWO_CHANGED
INPUT_TWO_RESET
IP_CONFLICT
IR_FILTER_DAY_AUTO
IR_FILTER_DAY_MANUAL
Cisco Video Surveillance 4300 and 4500 High-Definition IP Cameras User Guide
3-38
Description that Appears in Log File
Factory defaults restored successfully
by user <user> <IP address or
hostname>.
Device rebooted.
Device was rebooted manually by user
<user> <IP address or hostname>.
DHCP lease renewal was successful.
The Codec/Sensor module's DSP
encoding was halted. Either the analog
image signal from the sensor has been
lost, or an internal encoding error has
occurred.
Event triggered: email sent to <e-mail
address>.
Bit Error Rate (BER) exceeded
specified threshold of <threshold>.
Ethernet signal degrading.
Output frame rate does not match the
camera's configured frame rate.
Upgrading firmware failed from user
<user> <IP address or hostname>.
Firmware upgraded successfully from
user <user> <IP address or hostname>.
Event triggered: notification sent to
HTTP server <IP address or
hostname>.
Input port one changed to <high/low>. Input port 1 on the IP camera changed
Input port one reset to <high/low>.
Input port two changed to <high/low>. Input port 1 on the IP camera changed
Input port two reset to <high/low>.
IP Address conflict for <IP address>.
IR filter changed to day automatically. The IP camera enabled its day filter
IR filter manually changed to day by
user <user> <IP address or hostname>.
Chapter 3 Configuring and Managing the IP Camera
Explanation
The IP camera was reset to its factory
default configuration.
The IP camera rebooted automatically. 5
The IP camera was rebooted by a user. 5
The IP camera renewed its DHCP
lease.
The DSP of the IP camera codec/sensor
module DSP stopped encoding. The
analog image signal from the sensor
may be lost or an internal encoding
error may have occurred.
An event occurred and e-mail
notification of the event was sent.
The bit error rate (BER) exceeded the
specified threshold.
The IP camera detected a degrading
Ethernet signal.
The IP camera is sending video at a
frame rate that does not match the
configured frame rate.
An attempt to upgrade the IP camera
firmware failed.
The IP camera firmware was updated.
An event occurred and HTTP
notification of the event was sent.
state.
Input port 1 on the IP camera reset to
its default state.
state.
Input port 1 on the IP camera reset to
its default state.
IP camera experienced an IP address
conflict.
automatically.
The IP camera day filter was enabled
by a user.
Severity
5
6
2
5
4
4
3
0
5
5
5
5
5
5
4
6
6
OL-19609-04