Firmware Settings Window - Cisco 4300 User Manual

Chapter 3 Configuring and Managing the IP Camera
Table 3-19
Option
Import configuration to
camera

Firmware Settings Window

The Firmware Settings window lets you view information about the firmware that is installed on the IP
camera and upgrade the firmware.
Before you upgrade firmware, download the firmware file to a PC that is accessible on your network and
unzip the file if it is zipped. To download firmware, go to this web page:
http://www.cisco.com/en/US/products/ps6918/Products_Sub_Category_Home.html
After you upgrade firmware, the IP camera restarts automatically. It retains all configuration
information.
To display the Firmware Settings window, access the configuration windows as described in the
"Performing the Initial Setup of the IP Camera" section on page
Firmware.
If you change any options in this window, you must click the Save Settings button to save the changes.
If you do not click this button, changes are not retained when you exit the window. Save Settings appears
at the bottom of the window. You may need to scroll down to it.
Table 3-20
Table 3-20
Option
Device Information Area
IP Address
MAC Address
Device Name
OL-19609-04
Maintenance Settings Window Options (continued)
Description
Path and folder where a configuration file is stored. You can click Browse to
find this location. After you enter this information, click Import to load the
configuration file to the IP camera.
After you upload a configuration file to the IP camera, the IP camera restarts
automatically.
If you upload configuration from another IP camera that is active in your
network, make sure to configure this IP camera with a name, description, and
unique IP address (if not obtained through DHCP). To change these options,
see the "Basic Settings Window" section on page 3-16
Addressing Window" section on page
A configuration file that you upload includes the passwords that are
configured for the administrator and for users. If you change any passwords
after saving the configuration file, be aware that uploading the file overwrites
the new passwords with the saved ones.
describes the options in the Firmware Settings window.
Firmware Settings Window Options
Description
Display only. IP address of the IP camera
Display only. MAC address of the IP camera.
Display only. ID of the IP camera, as configured in the Basic Settings
window. For more information, see the
page 3-16.
Cisco Video Surveillance 4300 and 4500 High-Definition IP Cameras User Guide
Administration Windows
and the "IP
3-17.
2-5, click Administration, then click
"Basic Settings Window" section on
3-31