Table of Contents
Advertisement
Electrical connections
Any work required on the cooker
must be carried out by a
EXPERT
qualified people can impair the
cooker and cause injury to people
and/or damage to property.
The electrical installation is to include a
device whereby it is possible to separate all
the poles of the equipment from the power
supply, with a contact opening of at least
3 mm.
This requirement must be satisfied for
safety reasons.
The connected rating and voltage are
shown on the data plate. There is a wiring
diagram on the back of the cooker.
Base trim
CAUTION! Take due care when
fitting the base trim to the cooker.
Edges which you do not normally
come into contact with can be sharp.
!
IMPORTANT
ONLY FITS COOKERS WITH
900
A HEIGHT OF
Remove the protective film before fitting the
base trim.
1 Remove the drawer from the cooker
by lifting it diagonally upwards and
then pulling it all the way out.
2 Fit the base trim by pressing it firmly
onto the plinth (snap attachment, no
tools needed).
3 Replace the drawer.
QUALIFIED
. Work carried out by non-
.
MM
9
Advertisement
Table of Contents
