What To Do If - Electrolux EBGL6X User Manual

Caution! Be careful when you remove
the door from the appliance. The door
is heavy. There is a risk of injury or
damage to the appliance.
Removing the door
1. Open the door as far as it goes.
2. Fully press the clamping levers (A) on
the two door hinges.
A

WHAT TO DO IF...

Warning! Refer to "Safety information"
chapter.
Problem
The appliance does not heat up
The appliance does not heat up
The appliance does not heat up
The appliance does not heat up
The appliance does not heat up
The oven lamp does not oper-
ate
The display shows F102
3. Close the door until the first position
4. Hold the door with one hand on each
A
Installing the door
To install the door follow the procedure in
reverse.
Possible cause
The appliance is deactivated
The time of day is not set
The necessary settings are not
set
The automatic switch-off is ac-
tivated
The fuse is released
The oven lamp is defective
The door lock is defect
(angle approximately 45°).
45°
side and pull it away from the appliance
at an upwards angle.
Put the door with the outer side down
on a soft and level surface to prevent
scratches.
Activate the appliance
Set the clock. Refer to "First
setting the time of day"
Make sure, the settings are
correct
Refer to „Automatic switch-off"
Make sure, if the fuse is the
cause for the malfunction. If the
fuse releases again and again,
refer to an authorized electri-
cian
Replace the oven lamp.
• Close the door correctly
• Deactivate the appliance with
the house fuse or the safety
switch in the fuse box and
activate it again
• If the display shows F102
again, refer to the Service
Center
electrolux 17
Solution