Table of Contents
Advertisement
10 electrolux
SYMBOL
FUNCTION
SETTING THE DURATION
1. Activate the appliance and set an oven
function and temperature.
2. Touch
again and again until the dis-
play shows
flashes in the display.
3. Use
or
RATION.
4. Touch
to confirm
5. Use
or
TION.
If you touch
hours for DURATION, the appliance
goes to setting of the END function.
6. When the set time ends, an acoustic
signal operates for two minutes.
symbol and time setting flash in the
display. The appliance deactivates.
Touch any sensor field or open the
oven door to stop an acoustic signal.
7. Deactivate the appliance.
SETTING THE END
1. Activate the appliance and set an oven
function and temperature.
2. Touch
again and again until the dis-
play shows
flashes in the display.
3. Use
or
minutes and then hours) and
to confirm.
4. When the set time ends, an acoustic
signal operates for two minutes.
symbol and time setting flash in the
display. The appliance deactivates.
5. Touch any sensor field or open the
oven door to stop an acoustic signal.
6. Deactivate the appliance.
SETTING THE MINUTE MINDER
Use the MINUTE MINDER to set a count-
down (maximum 2 h 30 min). This function
END
To set when the appliance deactivates. You can use Duration
and End at the same time (Time delay), if the appliance is to
.
to set minutes for DU-
to set hours for DURA-
or
during setting
.
to set END (first you set
or
DESCRIPTION
be activate and deactivate automatically later.
has no effect on the operation of the oven.
You can set the MINUTE MINDER any time,
also if the appliance is off.
1. Touch
and "00" flash in the display.
2. Use
or
MINDER. First you set the seconds and
then minutes and hours.
3. Touch
reset the set time.
4. Touch
starts automatically after five seconds.
5. When set time ends, an acoustic signal
operates for two minutes. "00:00" and
flash in the display.
6. Touch a sensor field or open the appli-
ance door to stop the acoustic signal.
SETTING THE TIME DELAY FUNCTION
DURATION
the same time, if the oven is to be switched
on and off automatically later. In this case
first set DURATION
function (refer to "Setting the DURATION"
and "Setting the END ").
When the Time delay function is activated
the display shows static symbol of the oven
function,
with a dot and
shows which clock function is on in the
Clock/Residual heat display.
COUNT UP TIMER
Use the Count Up Timer to monitor how
long the appliance operates. It is on imme-
diately when the appliance starts to heat.
Reset the Count Up Timer: Touch
and at the same time until the display
shows "00:00" and the Count Up Timer
starts to count up again.
You cannot use Count Up Timer when
Duration or End is set.
.
to set the MINUTE
and
at the same time to
or the MINUTE MINDER
and END
can be used at
and then END
. The dot
Advertisement
Table of Contents
