Table of Contents
Advertisement
2. Slide the oven flush into the recess.
Caution! Make sure the cable is free
when you move the appliance.
A
3. Use a minimum of 2 screws to attach
the oven on the 2 sides (Detail A).
INSTALLING THE OVEN UNDER A
WORK SURFACE
Warning! Installation into flammable
material must agree with NIN 2005,
chapter 4.2.2 of the VKF (Swiss
Association of the Cantonal Fire
Insurance Companies) fire protection
guidelines and regulations.
A = appliance
N = recess
1. Pull the appliance drawer out as far as
it goes and remove it.
2. Use the side handles to hold the oven
and slide it flush into the recess.
Caution! Make sure the cable is free
when you move the appliance.
A
3. Use a minimum of 2 screws to attach
the oven on the 2 sides (Detail A).
Warning! When installing next to a
wood-fuelled boiler, a heatproof and
heat-insulating plate must be mounted
at the height of the appliance and at
least 30 cm deep.
ELECTRICAL CONNECTION
Important! Let a qualified electrician
connect the appliance to the electricity
supply.
Use a power cable of the type H05VV-F or
higher.
Install the appliance with a socket supply
line. If there is no socket supply line, the
fixed home electrical system must include
an isolating device with at least a 3 mm-
contact separation to enable a simultane-
ous and all-pole cut off from the mains (ac-
cording to NIN 2000). The customer must
have a socket for the electrical connection
that is accessible and outside the coordina-
tion room. The length of the connection ca-
ble must be approximately 120 cm with
lines connected directly to the mains.
electrolux 19
min. 20
B
15
20
A
Advertisement
Table of Contents
