Temperature Setting Lock; 1.0 Hot Tub Maintenance; 1.1 Cleaning The Filter - Sundance Spas 850Export Series Installation & Owner's Manual

ENGLISH
To Lock The Panel: Press the DISPLAY, MODE, and UP sensor pads,
in order, within five seconds. A padlock symbol will appear on the LCD
screen. With the panel locked, none of the components can be turned on
and the only settings that can be adjusted are the standard/economy oper-
ating mode and changing the time of day. All automatic hot tub functions
will operate normally.
To Unlock The Panel: Press DISPLAY, MODE, and DOWN, in order,
within five seconds. The "lock" symbol will disappear. All sensor pads
are now active.

10.6 Temperature Setting Lock

To electronically lock the temperature setting, first enter the "temperature set-
ting" mode by pressing UP or DOWN. Then, within five seconds, press the
three sensors described under "To Lock The Panel" above. This will prevent
the temperature setting from being changed by unauthorized persons but all
other sensors will remain active. To unlock the temperature setting so that
it can be adjusted, simply follow the instructions above under "To Unlock
The Panel" above.

11.0 Hot Tub Maintenance

Proper and regular maintenance of your hot tub will help it retain its beauty
and performance. Your authorized Sundance Dealer can supply you with all
the information, supplies, and accessory products you will need to accom-
plish this.

1 1.1 Cleaning The Filter

Your Sundance hot tub is equipped with an exclusive MicroClean
2-stage filter located under the filter lid (Figure-F, Page 14). Larger debris is fil-
tered by pump #1 drawing water through the larger (stage 1) cartridge dur-
ing normal operation and at each filter cycle. Fine debris is filtered by the cir-
culation pump drawing water through the smaller (stage 2) cartridge. Both
halves work together to give you unsurpassed water quality! To ensure opti-
mum performance, clean and reuse the stage 1 cartridge once a month and
replace the stage 2 cartridge every 3 months.
All models include filters on their footwell suction covers (Page 17) that
prevent debris from entering pump 2, when operating. These filters
must remain in place to protect pump 2's plumbing network. They
should be cleaned every 2 months, or when weak pump 2 perfor-
mance is observed.
Page 26
LOCKED
LOCKED
TM