Sundance Spas 850Export Series Installation & Owner's Manual page 2

ADDENDUM - All 2004+ Hot Tub Models
850 Series Owner's manual, #6530-317, Rev-A (Export)
The following changes apply to the owner's manual listed above:
• New Sundance Fluidix Intelli-Jet which replaces all Intelli-Jet LX
jets.
• New convenient change filter reminder display. This feature
displays the words "change filter" on the control panel display
after a specified number of days to remind the spa owner to
clean and/or replace their filter cartridges.
• Revised 2004 Hot Tub Gravity Drain Draining Procedure
• Revised 2004 Cameo Hot Tub "Top View" (Figure-F) and Cameo
Jet/Air Controls Diagram.
Please refer to the instructions below for proper Fluidix Intelli-Jet
operation details, Change Filter reminder setup instructions, and
Cameo Air/Massage selector operation details.
Fluidix Intelli-Jet Operation Details
The Fluidix Intelli-Jets in your new spa offer the advantage of no
moving parts and zero maintenance. They can also be adjusted for
a high and low impact massage, providing the ultimate massage!
Each jet has it's own water volume and directional or oscillating flow
adjustment. The jet's outer dial controls water volume (flow rate)
and it's center "mode disk" selects either an oscillating or directional
flow massage.
Fluidix Intelli-Jet Adjustment
1. Turn outer dial (A) clockwise to increase water
volume. Turn outer dial counterclockwise to
decrease water volume or to shut jet off.
2. Rotate center "mode disk" (B) clockwise to select
a non-oscillating water stream or turn counter-
clockwise to select an oscillating stream at any
angle.
3. For a high impact massage, turn corresponding
air control knob clockwise. For low impact
massage, turn corresponding air control knob
counterclockwise.
Note: Always keep at least 6 adjustable jets open at
all times on each jet system.
6530-520, Rev. B © 2004 Sundance Spas, Inc.
New Fluidix
Intelli-Jet
B
A
Air
Control Knob
Printed in U.S.A.