Sundance Spas 850Export Series Installation & Owner's Manual page 18

When power is turned on, the spa defaults to STANDARD mode. In
STANDARD mode, the filter cycle will operate pump 1 as programmed
to provide skimming action and additional filtration. In ECONOMY
mode, the filtration cycle will not come on. This is the main difference
between the two operating modes.
WARNING - RISK OR INJURY
Always check the water temperature carefully before entering the
hot tub.
H. Setting Desired Temperature
To warm hot tub water to a comfortable temperature, follow these steps:
• The LCD display on the control panel displays the actual temperature of
the hot tub water. Press either the COOLER (Down) or
WARMER (Up) sensor pad once to display the "set tempera-
ture" for 5 seconds. If you want the water to heat to a different
temperature, simply press COOLER (Down) or WARMER (Up)
within 5 seconds. The set temperature advances or decreases
by one degree each time one of these sensor pads is pressed.
• The heater will turn off when the temperature corresponding to the
thermostat setting is achieved.
Important Heater Details:
• The maximum temperature for which the hot tub can be set is 40 °C and the
minimum is 26 °C.
• Setting the thermostat at maximum will not accelerate the heating process.
This will only result in a higher ultimate temperature.
• The heater operates until the water reaches the programmed "set
temperature" , then turns off. The heater will reactivate after the water cools
to approximately 1 °C below the "set temperature."
I. Place Cover On Hot Tub
• Keeping the insulating cover in place anytime the hot tub is not in use will
reduce the time required for heating, thereby minimizing operating costs.
• The time required for initial heat-up will vary depending on the starting
water temperature and the capacity of your hot tub. Larger hot tubs heat
at about 2 to 3 °C per hour; smaller hot tubs heat at a rate of approxi-
mately 4 to 5 °C per hour.
ENGLISH
Page 11