N O T E
The HomeBase
Configuration program
cannot be used to select the
baud rate on the Compact
HomeBase.
C H A P T E R
8
U S I N G
Back Panel
Power
Supply
Connector
There is a power supply connector and an RS232 connector:
Power supply connector
HomeBase. The power supply provides 12V DC input for communications and
battery charging.
RS-232 Communications Port
RS-232 device.
Bottom Panel
A Baud Rate DIP switch is located on the bottom of the HomeBase. The three-
position DIP switch is used to select the communication baud rate. Switch position
and the corresponding baud rates are shown in the chart below.
T H E
D O L P H I N
7 2 0 0
Figure 17 HomeBase Back Panel
Use this connector to attach a power supply to the
Use a standard serial cable to connect this port to a host
Figure 18 HomeBase Bottom Panel
99
C O M P A C T
H O M E B A S E
RS-232
Connector
Baud Rate
Switch