Hand Held Products Dolphin 7200 User Manual page 84

C H A P T E R 7 U S I N G
Configuration switches
modes for your Dolphin. See Chapter 8 for more on the configuration switch settings.
Service Aux Batt switch
battery in the auxiliary battery well. For maximum battery life, the battery should be
serviced, or calibrated once a month. The Charging AUX BATT LED is red while the
battery is discharging and changes to blinking red when the charging cycle begins. The
battery is ready to use when the light turns green.
Power supply connector
HomeBase. The power supply provides 12V DC input for communications and
battery charging.
Side Panels
There is a main communications port on one side and a multi-HomeBase-port on the
other side:
Figure 12 HomeBase Side Panel
Main Communications Port
Multi-HomeBase Port
HomeBase Network. This port mates with the next
HomeBase's main communications port to form an
addressable network. Note: The Multi-HomeBase Port
cannot be used for communications to
standard serial devices.
T H E D O L P H I N
Use these switches to select the network and communications
Press and hold this button for four seconds to service the
Use this connector to attach a power supply to the
Main Communications Port
to connect this port to a host RS-232 device if the
Dolphin HomeBase is the first unit of HomeBase
network. Otherwise, the main communications port
connects to another Dolphin HomeBase Multi-
HomeBase Port to form a daisy-chained network. See
pinout definitions in the section on Setting Up the Dolphin
HomeBase later in this
chapter.
Use this port to form a Dolphin
84
7 2 0 0 H O M E B A S E
Use a standard serial cable
Figure 13 HomeBase Side Panel Multi-
HomeBase Port