Assembling The Hood - DeDietrich Cooker hood Manual To Installation

2 / INSTALLING YOUR APPLIANCE

ASSEMBLING THE HOOD

•
Warning
The hood must be installed in
compliance with all applicable regulations
concerning the ventilation of premises. In
France these regulations are described in
DTU 61.1 from the CSTB. In particular, the
evacuated air should never be conveyed to
a duct used to evacuate smoke from
appliances that
combustible fuels. Unused ducts may only
be used after approval from a competent
specialist.
The distance between the supporting surface for the
cooking vessels on the hob and the lower part of the
hood must be at least 35 cm. If the instructions for
installation for the hob specify a greater distance, this
has to be taken into account.
A
b_255
use gas or other
fig. 3
fig. 5
- Opening the back panels:
when installing, it will be necessary to open the
back panels:
to open them, grip them by the lower part and
turn them outwards as far as they can go (Fig.3);
release gently until they lock.
- Fixing to the wall: Draw a line on the wall in
vertical line with your hob. Mark the first 4 holes to
be drilled in the wall, respecting the distances
indicated in Fig. 4. Drill the 4 holes and fit the screw
anchors provided. Fix the metal brackets (A) to
the wall using the holes just drilled (Fig. 5); the
screws for fixing the bracket are provided.
Hang the hood on the brackets (Fig. 6). Adjust the
horizontal position moving the hood to the right or left
so that it is aligned with the wall units. When adjustment
has been completed, without removing the hood,
mark the other 2 holes to be drilled (C) in the wall.
Remove the hood and drill the holes marked (8 mm
diameter). Then use the 2 screw anchors and the 2
screws provided for final fixing.
ø8
fig. 6
25
695
55
min 870
fig. 4
EN