Ducting Mode - DeDietrich Cooker hood Manual To Installation

EN 2 / INSTALLING YOUR APPLIANCE

Ducting mode

•
- Assembly of the flange: install the flange in the
device air outlet and press slightly (Fig.7).
- Fixing of the telescopic decorative flue (on
request)
- Adjust the width of the support bracket (D) of the
telescopic flue by means of the screws (E) as
shown in Fig.8; then, by means of the screw anchors
and screws (F) provided, fix the bracket to the
ceiling in such a way that it is positioned along the
axis with your hood.
- Connect the air outlet pipe to the air vent of the
hood. Use a flexible pipe and lock it to the air vent
of the hood with a metal hose clamp - Fig. 13 (pipe
and clamp are not provided).
- Carry out the electrical connection of the hood
using the power supply cable.
- Insert the extension flues setting them on the
hood; extend the upper flue to the ceiling and
secure with the 2 screws (H) - Fig.10.
fig. 7
fig. 9
Warning
This is the filtering version of your
cooker hood; you must first remove the
charcoal filter.
Tip
For optimal use of your appliance, we
recommend that you connect the hood to a
150 mm-diameter flue (not delivered with the
appliance). Minimise the number of angles
and bends and the lengths of the flue. In
the event that the hood will be operated
using out-door evacuation, you should
ensure a sufficient inflow of fresh air to
avoid a pressure deficiency in the room.
H
fig. 10
26
E
F D
=
F
=
fig. 8
H
b_255