Valve Spring Installation; Retainer Lock Installation; Cylinder Head Bolt Installation - Mitsubishi 4G1 series Workshop Manual

Painted
end
SOHC
DOHC
MD998772
MD998735
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
4G1 ENGINE (E - W) -
"BA VALVE SPRING INSTALLATION
Spring (1) Install the valve spring such that its painted end is on
retainer
Stem seal
Spring seat
"CA RETAINER LOCK INSTALLATION
MD998772
"DA CYLINDER HEAD BOLT INSTALLATION
(1) Before reusing the cylinder head bolt, check that its nominal
(2) Fit the washer as shown.
(3) Apply engine oil to the bolt's thread and washer.
Nov. 1995
Dec. 1998
Cylinder Head and Valves
the rocker arm side.
length does not exceed the specified limit. Replace the
bolt if this measurement exceeds the limit.
Limit: 103.2 mm
PWEE9520
PWEE9520-A
11A-9-9
Revised