4G1 ENGINE (E - W) -
Timing belt side
Thickness gauge
Timing belt side
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
"HA ROCKER COVER INSTALLATION
(1) Apply the specified sealant to the area shown, then fit
VALVE CLEARANCE ADJUSTMENT
<SOHC 12-VALVE>
(1) Position the No. 1 cylinder at top dead center on the
(2) Adjust the valve clearance at the points shown in the
(3) Loosen the adjusting screw locknut.
(4) Using a feeler gauge, adjust the valve clearance by turning
(5) While holding the adjusting screw with a screwdriver,
(6) Rotate clockwise the crankshaft one complete turn (360_
(7) Adjust the valve clearance at points as shown in the
(8) Repeat steps (3) to (5) to adjust the valve clearance
(9) With the engine mounted on vehicle, warm up the engine.
Nov. 1995
Dec. 1998
Rocker Arms and Camshafts
the rocker cover.
Specified sealant:
3M ATD part No. 8660 or equivalent
compression stroke.
illustration.
the adjusting screw.
Standard value: on cold engine
Intake 0.09 mm
Exhaust 0.17 mm
tighten the lock nut.
degree).
illustration.
of remaining valves.
Then, check for valve clearance on hot engine and adjust
if necessary.
Standard value: on hot engine
Intake 0.20 mm
Exhaust 0.25 mm
PWEE9520
PWEE9520-A
11A-8-9
Added