Bearing Cap Installation; Adjusting Screw Installation; Rocker Arm Shaft Installation - Mitsubishi 4G1 series Workshop Manual

4G1 ENGINE (E - W) -
Chamfer
Oil holes
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
"BA BEARING CAP INSTALLATION
(1) Position the camshaft dowel pins as shown.
(2) Bearing caps Nos. 2 to 5 are the same shape. Be sure
(3) Apply the specified sealant to the surfaces that are to
(4) Check that the rocker arms are installed correctly.
"CA ADJUSTING SCREW INSTALLATION
1 mm or less
(1) Install provisionally the screw to the rocker arm. Insert
"DA ROCKER ARM SHAFT INSTALLATION
(1) Place the end with the larger chamfered side toward the
(2) Place the section of the shaft with the oil holes toward
Nov. 1995
Dec. 1998
Rocker Arms and Camshafts
NOTE
With the camshaft dowel pins in this position, the camshaft
notches for tightening cylinder head bolt are correctly
positioned.
to install them in order of their cap numbers and check
the identification marks to ensure that the intake and
exhaust sides are not reversed.
Identification marks:
I: Intake
E: Exhaust
mate with the cylinder head. Then, tighten the bearing
cap bolts - for the middle caps first, then for the outer
caps, and soon. Tighten the bolts a little at a time such
that each bolt is tightened to the specified torque in the
final sequence.
Specified sealant:
3M ATD Part No. 8660 or equivalent
it so that the end of the screw is flush with the edge
of the rocker arm or projects slightly (1 mm or less).
flywheel side. <SOHC 12-VALVE>
Place the end with the larger chamfered side toward the
timing belt side. <SOHC 16-VALVE>
NOTE
The rocker arm shaft for intake valves have eight oil holes.
the cylinder head.
PWEE9520
PWEE9520-A
11A-8-7
Added