Mitsubishi 4G1 series Workshop Manual page 79

11A-9-10
Timing belt side
8 6 1
10 4 2
_
90
_
90
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
4G1 ENGINE (E - W) -
(4) Tighten the bolts in the sequence shown until each is
(5) Completely loosen the bolts.
(6) Retighten the bolts in the sequence shown until each is
3 9
5 7
(7) Apply paint marks to the cylinder head bolt heads and
(8) In accordance with the tightening sequence, tighten each
(9) Tighten each bolt by a further 90_ and check that the
Paint mark
Nov. 1995
Dec. 1998
Cylinder Head and Valves
torqued to 49 Nm.
torqued to 20 Nm.
cylinder head as shown.
bolt by 90_.
paint marks on the bolt head and cylinder head are aligned.
Caution
If the bolts are tightened by an angle of less than
90_, they may not hold the cylinder head with sufficient
strength.
If the bolts are tightened by an angle exceeding 90_,
completely remove them and carry out the installation
procedure again.
PWEE9520
PWEE9520-A Added