Mitsubishi 4G1 series Workshop Manual page 34

11A-4-6
E
Mitsubishi Motors Corporation
4G1 ENGINE (E - W) -
"DA TIMING BELT INSTALLATION
(1) Place the camshaft sprocket timing marks at the positions
(2) Align the crankshaft timing mark with the timing mark
(3) Turn the exhaust camshaft sprocket in the direction shown
(4) Use a bulldog clip to prevent the timing belt teeth from
(5) Fit the timing belt onto the idler pulley, crankshaft sprocket,
(6) Loosen the tensioner pulley mounting bolts by
(7) Remove the bulldog clip.
(8) Turn the crankshaft twice in the normal rotating direction
(9) Tighten the tensioner pulley mounting bolts.
Nov. 1995
Timing Belt
shown.
NOTE
After aligning the sprocket timing marks, let go of the
sprockets. The exhaust camshaft sprocket will rotate by
one tooth in the direction shown and remain stable in
this position.
on the front case.
and fit the timing belt with the timing marks aligned.
jumping.
and tensioner pulley in that order.
NOTE
When fitting the belt, keep the camshaft sprocket timing
marks correctly aligned and keep the tension side of the
belt tight.
of a turn and allow the tensioner spring to apply tension
to the timing belt.
(clockwise) and check that the timing marks are correctly
aligned.
Caution
This procedure utilizes the camshaft's driving torque
to apply tension evenly to the timing belt. Be sure
to turn the crankshaft as described above. Do not
turn the crankshaft in reverse.
PWEE9520
1 1
/ to /
4 2