Mitsubishi 4G1 series Workshop Manual page 62

4G1 ENGINE (E - W) -
MD998442
Diesel fuel
Diesel fuel
MD998442
Division = 1 mm
MD998440
Lash
adjuster
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
(7) Place the lash adjuster in container C. Then, gently push
(8) Stand the lash adjuster with its plunger at the top, then
(9) Remove the lash adjuster from the container, then stand
(10)Set the lash adjuster on the special tool MD998440 (leak
Lash adjuster
(11)Remove the bolt from the tester, then adjust the height
(12)After the plunger has moved downward slightly (0.2 to
Nut
Nov. 1995
Dec. 1998
Rocker Arms and Camshafts
down the internal steel ball using special tool MD998442.
Caution
Do not use container C for cleaning. If cleaning is
performed in container C, foreign matter could enter
the pressure chamber when chamber is filled with
diesel fuel.
push the plunger downward firmly until it moves through
its greatest possible stroke. Return the plunger slowly,
then release the steel ball and allow the pressure chamber
to fill with diesel fuel.
the lash adjuster with its plunger at the top. Push the
plunger firmly and check that it does not move. Also,
check that the lash adjuster's height matches that of a
new lash adjuster.
NOTE
If lash adjuster contracts, perform the operations (7)
through (9) again to fill it with diesel fuel completely.
Replace the lash adjuster if it still contracts after performing
these steps.
down tester).
as illustrated.
0.5 mm), measure the time taken for it to move downward
by a further 1 mm.
Standard value:
3 - 20 second/1 mm [with diesel fuel at 15 - 20_C
(59 - 68_F)]
PWEE9520
PWEE9520-A
11A-8-5
Revised