System Board
Description
System board for use in Windows 7 models (includes thermal material)
System board for use in NetClone models (includes replacement thermal material)
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front fan assembly
4.
When replacing the system board, make sure the following components are removed from the
defective system board and installed on the replacement system board:
●
Memory modules
●
Expansion cards
●
Heat sink
●
Processor
5.
Disconnect all cables connected to the system board, noting their location for reinstallation.
6.
Remove the eight Torx T15 screws that secure the system board to the chassis.
Figure 6-46
90
Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis
(Computer Access Panel on page
(Front Fan Assembly on page
(Memory on page
(Expansion Cards on page
(Heat sink on page
82).
(Processor on page
84)
System board screws
(Preparation for Disassembly on page
50).
55)
58)
Spare part number
703596-001
710096-001
49).
78).