System Board
Description
System board for use in Windows 7 models (includes thermal material)
System board for use in NetClone models (includes replacement thermal material)
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
When replacing the system board, make sure the following components are removed from the
defective system board and installed on the replacement system board:
●
Memory modules
●
Expansion cards
●
Heat sink
●
Processor
4.
Remove the baffle from the chassis
5.
Remove the fan from the chassis
6.
Rotate the drive cage to its upright position.
7.
Rotate the power supply to its full upright position.
8.
Disconnect all data and power cables from the system board.
9.
Disconnect the balance of the cables from the system board.
10.
Remove the eight Torx T15 screws (1) that secure the system board to the chassis.
134 Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
(Access Panel on page
(Memory on page
(Expansion Card on page
(Heat sink on page
129)
(Processor on page
131)
(Fan duct on page
(Front Fan Assembly on page
(Preparation for Disassembly on page
93).
98)
101)
122).
Spare part number
703596-001
710096-001
92).
123).