5.
Install four M3 metric guide screws in the lower holes on each side of the drive. HP has provided
eight extra M3 metric guide screws on the front of the chassis, under the front bezel. The M3
metric guide screws are black. Refer to
metric guide screws location.
NOTE:
the new one.
CAUTION:
internal components of the drive.
Figure 6-18
6.
Slide the drive into the drive bay, making sure to align the guide screws with the guide slots, until
the drive snaps into place.
Figure 6-19
68
Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis
When replacing the drive, transfer the four M3 metric guide screws from the old drive to
Use only 5-mm long screws as guide screws. Longer screws can damage the
Installing Guide Screws (Optical Drive Shown)
Sliding the Drives into the Drive Cage
Drives on page 63
for an illustration of the extra M3