HP Compaq Pro 6305 Maintenance And Service Manual page 110

4. Release the slot cover retention latch that secures the PCI slot covers by lifting the green tab on
the latch and rotating the latch to the open position.
Figure 7-7
5. Before installing an expansion card, remove the expansion slot cover or the existing expansion
card.
NOTE:
attached to the expansion card.
a. If you are installing an expansion card in a vacant socket, remove the appropriate
expansion slot cover on the back of the chassis. Pull the slot cover straight up then away
from the inside of the chassis.
Figure 7-8
102 Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
Opening the Expansion Slot Retainer
Before removing an installed expansion card, disconnect any cables that may be
Removing an Expansion Slot Cover