Miscellaneous Setup - Integra DTR-5.9 Instruction Manual

Advanced Setup—Continued

Miscellaneous Setup

This section explains items on the Miscellaneous menu.
1
Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
The main menu appears onscreen.
If the main menu doesn't appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [
buttons to select
"6. Miscellaneous," and then
press [Enter].
3 Use the Up and Down [ ]/[ ]
buttons to select an item, and
then press [Enter].
4
Use the Up and Down [
buttons to select an item, and
use the Left and Right [
buttons to change it.
The items are explained below.
5
When you've finished, press the
[Setup] button.
Setup closes.
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
Volume Setup
■ Maximum Volume
With this setting, you can limit the maximum volume.
The Maximum Volume range is Off, 79 to 30.
88
■ Power On Volume
This setting determines what the volume will be each
time the AV receiver is turned on.
The range is Last, Min, 1 to 79, Max.
To use the same volume level as when the AV receiver
was last turned off, select Last.
Note:
• The Power On Volume setting cannot be set higher
than the Maximum Volume setting.
■ Headphone Level
With this setting, you can offset the headphone volume
relative to the main volume. This is useful if your head-
phones are too loud or too quiet at the volume setting you
usually use when listening through your speakers. The
]/[ ]
headphone level can be set from –12 dB to +12 dB.
■ Zone 2 Maximum Volume
With this setting, you can limit the maximum volume for
Zone 2.
The Maximum Volume range is Off, 79 to 30.
■ Zone 2 Power On Volume
This setting determines what the volume will be for Zone
2 each time the AV receiver is turned on.
The range is Last, Min, 1 to 79, Max.
To use the same volume level as when the AV receiver
was last turned off, select Last.
OSD Setup
]/[ ]
■ Immediate Display
This setting determines whether operation details are
]/[ ]
displayed onscreen immediately after an AV receiver
function is used.
On: Displayed (default).
Off: Not displayed.
Even if On is selected, operation details are not output if
the input source is connected to a COMPONENT
VIDEO IN or HDMI IN.
■ Monitor Type
With this setting, you can specify the aspect ratio of your
TV so that menus are displayed properly.
16:9: Select if your TV is 16:9 (default).
4:3: Select if your TV is 4:3.
■ Display Position
This setting determines where on the screen operation
details are displayed.
Bottom: Bottom of the screen (default).
Top: Top of the screen.
■ TV format (not North American model)
For the onscreen setup menus to display properly, you
must specify the TV system used in your area.
Auto: Select this to have the AV receiver automati-
cally detect the TV system from the video input
signals.
NTSC: Select if the TV system in your area is NTSC.
PAL: Select if the TV system in your area is PAL.