Table of Contents
Advertisement
C38-VF Gas Fireplace
Removing and Installing
the Door
removing the Door:
Remove the trim (as described on the next page) to access the door
latches. open the latches by pulling Part A upwards and towards
you to disengage Part B from the door. Lift Part B clear of the door.
Repeat for all three latches. Be sure to hold the door carefully so it
does not fall. (See figure 8a.)
Figure 8a. Operating the door latches.
Figure 8b. Removing the door.
once the three latches are unhinged, tilt the top of the door forward
and lift it out of the slots. See figures 8b and 8c.
Caution:
The screen door must be replaced prior to oper-
■
ating the heater.
Page 6
Installation
Figure 8c. Removing the door.
re-installing the door:
To re-install the door, tilt the top edge towards you and line up the
tabs of the bottom of the door with the slots on the fireplace. Place
the tabs into the slots, and tilt the top of the door back towards the
fireplace as far as it will go. Close the latches by hooking Part B onto
the groove at the top of the door and pushing Part A down completely.
Installing the logs:
The C38-VF is supplied with a single-piece,moulded design, fibre
logset. The logset is very fragile and must be handled very carefully.
1. Remove the door as shown in Figures 8a-8c.
2. To install the logs, align the pins on the bottom of the log rest with
the holes in the bottom of the logset.
3. Re-install the screen door before operating the fireplace.
removing the logs:
Remove the door and carefully lift the logset off the two guide pins.
Handle the logs very carefully.
Figure 9a. Positioning for the logset.
■ If logs are not placed properly, excessive sooting
will result.
■ The surface of the logs will crack due to the heat from
the flames. This is a normal occurance.
■ The use of ember material is strictly prohibited.
Installing the Logset
Log 'C'
Log 'B'
Cautions:
Part No. XG0317
Advertisement
Table of Contents
