Removing And Installing The Door - Montigo HR38DF Installation, Operation & Maintenance Manual

H38DF Series Gas Fireplace
Removing and Installing
the Door
Removing the door:
The H38DF-Series door is removed in a few simple steps. Follow these
Steps below to remove the Horizontal access panel, unlatch the door
buckles and, remove the door. Replace in reverse order.
Step 1: Remove the Horizontal Access Pan-
Remove the Horizontal cover
by placing fingers in both finger
holes, then pushng away from
you and lifting out. Place it
aside during maintenance or
cleaning.
Install in reverse order.
Figure 28. Removing and installing the the Horizontal Acess Panel
Locate the Door Buckles:
Step 2:
Figure 28a. Loccate the door buckles. (Both Sides Typical)
Release the Door Buckles
Step 3:
Hand-hold
Figure 28b. Door buckle Tool
Step 4:
Firmly grasp hand-hold
end of Door buckle tool
and place the machined
end in the slot under door
frame. (as shown)
Figure 28c.
Page 16
Installation
Finger Holes
Installed Gas
Valve Cove r
Door Latch Slot
Door Latch Hook
1
Step 5:
Ensure the tool is firmly
in the lower end of the
slot, (as shown), Then pull
toward you (Caution: hold
the tool securely).
Figure 28d.
Step 6:
Pull hard if necessary to
release the spring ten-
sion. (Caution: The latch
springs back with force,
hold the tool securely).
Figure 28e.
Step 7:
Remove the tool from
the latch slot. Ensure the
latches are hanging freely,
the hook end is released
from the bottom of the door.
(Repeat all 4-steps for the
remaining latches).
Figure 28f.
Step 8:
Removing the Door:
Grasp the Door on either side, usually midway and lift upward, lift
the door carefully up and away from the front of the fireplace. See
figures 28g. Place the Door aside in a safe place while maintenance
and / or cleaning is being performed.
Figure 28g. Removing and installing the glass door.
Installing the Door:
To install the door, hook the top edge of the door frame into place.
Lower the door into position and follow the previous steps shown in
reverse order.
2
3
4
Part No. XG0147 - 011410