Rear Turn Signal Light Bulb - Yamaha MAJESTY YP125E Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
Replacing a tail/brake light
bulb or a rear turn signal
light bulb
Tail/brake light bulb
1. Remove the tail/brake light lens
by removing the screw.
6
1. Screw
2. Tail/brake light lens
3. Bulb
2. Remove the burnt-out bulb by
pushing it in and turning it coun-
terclockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
EAUS1133 4. Install the lens by installing the
screw. NOTICE: Do not over-
tighten the screws, otherwise
the lens may break.

Rear turn signal light bulb

1. Remove the left or right tail/brake
light lens by removing the screw.
2. Remove the turn signal light lens
by pulling it backwards.
3
3. Remove the turn signal light bulb
lens by removing the screw.
2
1
1. Turn signal light lens
2. Screw
3. Turn signal light bulb lens
4. Bulb
4. Remove the burnt-out bulb by
pushing it in and turning it coun-
terclockwise.
5. Insert a new bulb into the socket,
6. Install the turn signal light bulb
[ECA10681]
7. Install the turn signal light lens.
8. Install the tail/brake light lens by
4
3
2
1
6-29
push it in, and then turn it clock-
wise until it stops.
lens by installing the screw.
NOTICE: Do not overtighten
the screws, otherwise the lens
may break.
[ECA10681]
installing the screw. NOTICE: Do
not overtighten the screws,
otherwise the lens may break.
[ECA10681]