General
All bulb specifications are given on page 229.
The following list contains bulbs and point-
source lamps that are specialised or unsuitable
for changing except at a workshop:
•
General interior lighting in the roof
•
Reading lamps
•
Glovebox lighting
•
Direction indicators, door mirror
•
Approach lighting, door mirror
•
Brake lights
•
Active Bi-Xenon , Bi-Xenon and LED
lamps
WARNING
On cars with Bi-Xenon and Active Bi-Xenon
headlamps, Xenon lamp replacement must
be carried out at an authorised Volvo work-
shop. The headlamps must be handled with
extreme care due to the Xenon lamp's high-
voltage unit.
IMPORTANT
Never touch the glass part of the bulbs with
your fingers. Grease and oils from your fin-
gers are vaporised by the heat, coating the
reflector and then causing damage.
06 Maintenance and specifications
Front lamp housing
All front bulbs (except those for fog lamps) are
replaced by first removing the whole lamp
housing from the engine compartment.
WARNING
Always switch off the ignition and remove
the remote control key before starting to
replace a bulb.
Removing the headlamp
1.
Press quickly on the START-/STOP but-
ton and remove the remote control key.
2. (Upper illustration)
Withdraw the lamp housing's locking
pins.
Pull the lamp housing straight forward.
IMPORTANT
Do not pull the electrical cable, only the con-
nector
3. (Lower illustration)
Detach the lamp housing connector by
pressing down the clip with your thumb.
At the same time, guide out the con-
nector with your other hand.
4. Lift out the lamp housing and place it on a
soft surface to avoid scratching the lens.
5. Replace the bulb in question, see
page 229.
Installing the headlamp
1. Plug in the connector, a clicking sound
should be heard.
Lamps
06
223