Volvo S80 Owner's Manual page 143

04 Comfort and driving pleasure
Audio system
SCAN
Press to activate
Scanning can also be selected in DAB-PTY
mode. In which case only the preset type of
channels is played.
Stop scanning by pressing SCAN once, or
by pressing EXIT.
Subchannel
Secondary components are usually named
subchannels. These are temporary and can
04
contain e.g. translations of the main pro-
gramme into other languages.
If one or more subchannels are broadcast then
the > symbol is shown to the right of the chan-
nel name in the display. A subchannel is shown
by means of the > symbol appearing to the left
of the channel name in the display.
To access a subchannel:
Press
To navigate between subchannels:
Press or
Subchannels can only be accessed on the
selected main channel and not on any other
one without selecting it.
DAB PTY (program type)
DAB PTY selects one type of radio pro-
gramme. There are 29 different programme
142
types which also include different programme
categories. After selecting a programme type,
navigation only takes place within the channels
broadcasting that type.
Exit this mode as follows:
Press EXIT
It is also possible to select a preset channel or
exit DAB-PTY via the menu. In certain cases
DAB radio will exit PTY mode when DAB to
DAB linking (see below) is implemented.
DAB to DAB link
It is possible to exit a channel with poor or no
reception to the same channel in another chan-
nel group with better reception. There may be
a certain delay when changing channel group.
There may be a short silence between the
availability of the current channel finishing to
the availability of the new channel starting.
DAB display settings
1. Basic - Only the channel name is shown if
a primary component is being played. A
subchannel name is shown if it is a sub-
channel being played
2. Ensemble mode - Adds the channel
group name to the channel name
3.
Ensemble + PTY - Adds the programme
type name under the channel name
Presets
A preset contains one channel but no sub-
channel. If a subchannel is being played and a
preset is saved then only the channel ID is reg-
istered. This is because subchannels are tem-
porary. At the next attempt to retrieve the
preset, the channel which contained the sub-
channel will be played. The preset is not
dependent on the channel list.
A channel stored as a preset does not need to
be in the channel list to be loaded. If it is loaded
without the channel being available then a pre-
set number is shown and there is silence until
an available preset is selected for loading.
Alternatively another channel.
NOTE
The audio system's DAB system does not
support all functions available in the DAB
standard.
Menu structure
Main menu DAB
1. Select Ensemble
2. Select channel (Service)
3. Select Subchannel