Volvo S80 Owner's Manual page 113

03 Your driving environment
HomeLink EU*
•
Constant glow: The indicator lamp illu-
minates with a constant glow when the
button is kept depressed, this indicates
that the programming is complete. The
garage door, gate or similar should now
be activated when the programmed
HomeLink button is depressed.
03
•
Glow not constant: The indicator lamp
flashes quickly for approx. 2 seconds
and then changes over to a constant
glow for approx. 3 seconds. This proc-
ess is repeated for approx. 20 seconds
and indicates that the device has a "roll-
ing code". The garage door, gate or sim-
ilar is not activated when the pro-
grammed HomeLink button is
depressed. Continue the programming
in accordance with the following.
5. Locate the "programming button
receiver for the garage door for example,
normally located close to the antenna's
bracket on the receiver. If you have diffi-
culty in finding the button, look in the man-
ufacturer's manual or call the HomeLink
Hotline: 008000 466 354 65 (free of
charge). They can also be contacted via
the Internet: www.homelink.com
6. Depress and release the "programming
button". The button flashes for approx. 30
2 Button designation and colour vary depending on manufacturer.
*
112
Option/accessory, for more information, see Introduction.
seconds and the next step must be carried
out within this period.
7. Depress the programmed button on
HomeLink, while the "programming but-
ton" is still flashing, keep it depressed for
approx. 3 seconds and then release.
Repeat the press/hold/release sequence
up to 3 times to conclude the program-
ming.
Erasing programming
It is only possible to erase the programming for
all the buttons on HomeLink, not for individual
buttons.
Depress the two outer buttons and do not
release until the indicator lamp starts to
flash after approx. 20 seconds.
> HomeLink is now set in so-called "learn
2
" on the
mode" and is ready to be programmed
once more, see page 110.