Volvo S80 Owner's Manual page 142

•
Local – interrupts only if the radio station
transmitter is close.
•
4
Distant – interrupts if the station trans-
mitter is far away, even if there is a lot of
static.
•
Off
– no interruption for programmes from
other transmitters.
Resetting RDS functions
All radio settings can be reset to the original
factory settings.
The reset is carried out in FM mode under
FM settings Advanced radio settings
Reset all.
Volume control, programme types
The interrupting programme types, e.g. NEWS
or TP, are heard at the volume selected for
each respective programme type. If the volume
level is adjusted during the programme inter-
ruption, the new level is saved until the next
programme interruption.
4 Default/factory settings.
Radio system - DAB*
General
DAB (Digital Audio Broadcasting) is a digital
broadcasting system for radio.
Service and Ensemble
•
Service
- Channel, radio channel (only
audio services are supported by the sys-
tem).
•
Ensemble - A collection of radio channels
on the same frequency.
Programming of channel groups
(Ensemble learn)
When the vehicle is moved to a new broad-
casting area, programming of existing channel
groups in the area can take place.
Programming of channel groups creates an
updated list of all available channel groups.
The list is not updated automatically. Program-
Ensemble learn
ming takes place via the
menu or directly by means of a long press on
AUTO. If can take up to a minute to program a
channel group if both Band III and
selected.
Wavelength
DAB is transmitted on two wavelengths:
III and LBand .
04 Comfort and driving pleasure
•
Band III - over the whole country
•
LBand - mainly in large cities
By selecting for example
channel programming takes place more
quickly than if both
selected. It is not certain that all channel
groups will be found. Wavelength selection
does not affect the stored memories.
Navigation via lists
There are three types of basic list which can be
used for navigation:
•
Ensemble list
that the receiver has obtained via channel
group programming.
•
Service list
of the channel group to which they are allo-
cated. The list can also be filtered using
DAB-PTY
•
Subchannel list
selected channel.
The lists can be accessed via the menu. The
channel groups can also be accessed by
LBand are
pressing ENTER.
Scanning (SCAN)
Scanning means that all channels in the list are
Band
played for 10 seconds each.
*
Option/accessory, for more information, see Introduction.
Audio system
Band III on its own,
Band III and LBand are
- Shows channel groups
- Shows channels irrespective
(see below).
- Subchannels to a
04
141