Volvo S80 Owner's Manual page 249

06 Maintenance and specifications
Wheels and tyres
A foam block, located in the spare wheel rim,
contains all tools. The tools consist of a towing
eye, jack* and wheel wrench. The foam block
is screwed into a bracket in the bottom of the
spare wheel well.
Jack*
The original jack should only be used for
changing wheels. The jack's thread must
always be well greased.
Spare wheel*
The spare wheel (Temporary spare) is only
intended for temporary use. Replace the spare
wheel with a normal wheel as soon as possible.
The car's handling may be altered by the use
of the spare wheel. The correct tyre pressure
for the spare wheel is stated in the tyre pres-
sure table, see page 255.
06
IMPORTANT
Never drive faster than 80 km/h with a spare
wheel on the car.
IMPORTANT
The car must never be driven fitted with
more than one temporary spare wheel.
*
248
Option/accessory, for more information, see Introduction.
The spare wheel is located in the spare wheel
well with the outside down. Two foam blocks,
one under the spare wheel and one over/inside
affix the spare wheel in position. The upper one
contains all tools.
The same bolt runs through to secure the spare
wheel and the foam blocks.
Taking out the spare wheel
1. Fold the rear edge of the floor mat forward.
2. Undo the retaining screw.
3. Lift out the foam block with its tools.
4. Lift out the spare wheel.
The lower block does not need to be lifted out.
Tools - returning into place
The tools and jack must be returned to their
correct places after use. The jack must be
cranked to the correct position in order to have
space.
The foam block and spare wheel must be
replaced in the reverse order to taking out.
Note that there is an arrow on the upper foam
block. It must point forwards in the car.
IMPORTANT
Tools and jack must be stored in the
intended location in the car's cargo area
when not in use.
Changing wheels
Removing