Operation
Installing Brushes and Nozzle
FIG. 3/1
To install brushes, place
handle in upright position.
Tilt cleaner back so that it
rests on the oor. Align
post (A) on brush block
with hole (B) on bottom
of cleaner. Turn brushes
slightly until post ts easily
into hole.
Unfold Handle
FIG. 3/5
Raise upper handle to
upright position until it
locks in place.
vax.com.au
FIG. 3/2
Press brush assembly
rmly to snap into place.
FIG. 3/6
To lower handle, press
upper handle release button
and fold handle to storage
position.
FIG. 3/3
To install nozzle, make
sure latches (A) are out.
Align middle section of
nozzle with opening on
cleaner. Remove
cardboard packing insert
from squeegee area on
underside of nozzle.
Handle Release Pedal
FIG. 3/ 7
Step on pedal (A) to lower
handle to operating position.
Handle does not lock into a
single position, but " oats"
to allow convenient
operation.
FIG. 3/4
While holding nozzle
in place, slide latches
inward to lock in place.
4