Table of Contents
Advertisement
Operation
Filling the Solution (Upper) Tank
The solution tank holds solution and clean water that is to be dispersed onto the surface being cleaned.
NOTE: Disconnect cleaner from electrical outlet.
FIG. 4/3
Place cleaner handle in
upright, locked position.
To remove tank, squeeze
release button and pull
tank straight out.
IMPORTANT: Check for worn spots or joint separations before using, as these conditions could lead
to damaged ooring when using water to clean oor.
FIG. 4/6
Pour cleaning solution into
tank (A). Fill tank to ll line
(B) with warm water
(Max 40°C).
vax.com.au
FIG. 4/4
Carry tank to a sink. Rotate
tank cap counter-clockwise
and lift up to remove cap (A).
FIG. 4/7
If rubber ring (A) on cap
has become dislodged,
reposition it with uneven
side against ledge (B).
FIG. 4/5
Turn cap (A) upside down to serve as a measuring cup.
For hard surface oors such as vinyl, linoleum, marble,
laminate wood, polyurethane sealed wood or other
wood oors that can normally be cleaned using water,
use one cup of Vax cleaning solution.
FIG. 4/8
Replace cap. Rotate cap
clockwise until it locks
in place.
Cap must be locked
in place for proper
performance and to
prevent leaking.
FIG. 4/9
Slide tank straight
into position until latch
snaps in place.
6
Advertisement
Table of Contents
