Operation; Unfold Handle; Handle Release Pedal - Vax floormate VHFM700 User Manual

Operation

Installing Brushes and Nozzle
FIG. 3/1
To install brushes,
place handle in upright
position. Tilt cleaner
back so that it rests on
the floor. Align post (A)
on brush block with
hole (B) on bottom of
cleaner. Turn brushes
slightly until post fits
easily into hole.

Unfold Handle

FIG. 3/5
Raise upper handle to
upright position until it
locks in place.
www.vax.com.au
FIG. 3/2
Press brush assembly
firmly to snap into place.
FIG. 3/6
To lower handle, press
upper handle release
button and fold handle
to storage position.
FIG. 3/3
To install nozzle, make
sure latches (A) are
out. Align middle
section of nozzle with
opening on cleaner.
Remove cardboard
packing insert from
squeegee area on
underside of nozzle.

Handle Release Pedal

FIG. 3/ 7
Step on pedal (A) to
lower handle to
operating position.
Handle does not lock
into a single position,
but "floats" to allow
convenient operation.
FIG. 3/4
While holding nozzle
in place, slide latches
inward to lock in place.
4