Page 1
User Guide Vax Careline: AU: 1300 361 505 NZ: 0800 800 900 Hard floor cleaner Get Cleaning... What’s your Vax’s model number? What’s your serial number? (Located on the base of the machine) – – – – – Note these down in case you need them in future. Please keep instructions for further use.
Page 2
Vax Service line AU: 1300 361 505 / NZ: 0800 800 900...
Recovery tank lid and filter Carry handle Solution trigger Recovery tank Upper handle release button Mode selector Nozzle release buttons Cord hooks Clean solution tank cap Nozzle Handle release pedal Clean solution tank Squeegee Hard floor cleaning solution Clean solution tank release Bumper www.vax.com.au...
IMPORTANT: Cleaning filters maintains cleaning may reduce airflow. performance. Vax recommends that your filters should be checked and cleaned periodically. If your filters Keep hair, loose clothing, fingers and all parts of the are washable make sure they are completely dry before body away from openings and moving parts.
Step on pedal (A) to upright position until it upper handle release lower handle to locks in place. button and fold handle operating position. to storage position. Handle does not lock into a single position, but “floats” to allow convenient operation. www.vax.com.au...
To wet clean with brushes turned ON, turn the dial to the WASH position. For wet pickup, turn the dial to the WET PICKUP position. Vax Service line AU: 1300 361 505 / NZ: 0800 800 900...
Page 7
Vax cleaning solution. IMPORTANT: Check for worn spots or joint separations before using, as these conditions could lead to damaged flooring when using water to clean floor.
IMPORTANT: Do not use the cleaner to pick up flammable or combustible liquids or chemicals. Do not use the cleaner to pick up detergents that contain solvent based ingredients. Vax Service line AU: 1300 361 505 / NZ: 0800 800 900...
The Mode selector dial turns the brushes on and off as described in section 4. To release solution, Your Vax cleaner may be used to clean wood squeeze trigger (A) floors that have been sealed with a as needed and slowly...
Maintenance ( Keep your Vax as good as new ) Cleaning the Filters The tank lid contains a washable, reusable filter. Clean this filter when suction is low or reduced. Turn cleaner off and disconnect from electrical outlet. FIG. 6/1 FIG.
Maintenance ( Keep your Vax as good as new ) Cleaning the Nozzle Turn cleaner OFF and disconnect from electrical outlet. The cleaner’s nozzle can be removed for easy cleaning. FIG. 6/5 FIG. 6/6 FIG. 6/7 Slide the two nozzle Remove nozzle by Rinse nozzle under running water.
Maintenance ( Keep your Vax as good as new ) Cleaning the Brushes The brush assembly can be removed for easy cleaning. Turn cleaner OFF and disconnect from electrical outlet. Place handle in the upright position. Remove tanks to prevent leaking. Set aside.
Page 13
Ensure nozzle is replaced properly Nozzle not properly positioned and locked Excess cleaning solution foaming in tanks Use only Vax Floor Cleaner Water puddling behind cleaner Clean water tank not correctly installed Ensure tank is installed correctly Dirty water tank is full...
Monday-Friday 8.30am to 5.00pm If you have queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the standard local rate. Please make a note of the serial number and model number of the vacuum cleaner before calling.