Cleaning The Filters - Vax Floormate VHFM700 User Manual

Hard floor cleaner floormate
Hide thumbs Also See for Floormate VHFM700:
Table of Contents

Advertisement

Maintenance

Cleaning the Filters

The tank lid contains a washable, reusable lter. Clean this lter when suction is low or reduced.
Turn cleaner o and disconnect from electrical outlet.
FIG. 6/1
Remove recovery tank
and lid as described on
page 7.
Remove lter lid (A), then
remove lter (B).
IMPORTANT: Even with regular cleaning, lters have a limited lifespan and will eventually need to be
replaced during the lifetime of the hard oor cleaner. If the performance of your hard oor cleaner
is compromised and/or the lters are severely discoloured, the lters may need to be replaced. As a
general guide, Vax recommends lters are replaced every 3-6 months depending on the level of use to
ensure optimum performance of your hard oor cleaner.
9
(Keep your Vax as good as new)
FIG. 6/2
Remove loose debris from
lter by tapping the lter
or gently brushing using
your hand. The lter may
also be rinsed for additional
cleaning. Allow lter to air
dry between uses (allow
24hrs to dry completely).
Reposition lter. Replace
lter lid. Press down rmly
until snapped in place.
FIG. 6/3
Dry or loose debris will also
collect on the lter screen
located in the tank lid.
To remove debris from
screen, remove the pleated
lter from the lid. Remove
debris from screen (A).
The lter screen may also
be cleaned by rinsing it
under running water.
Vax Service line:
FIG. 6/4
Reposition pleated lter in
lid. Replace lid onto
recovery tank, pressing
down rmly until snapped
in place.
To replace recovery tank,
place bottom of tank
behind ledge (A) and push
tank straight into cleaner
body until it is locked
in place.
AU: 1300 361 505
NZ: 0800 800 900

Advertisement

Table of Contents
loading

Table of Contents