Table of Contents
Advertisement
Operation
Emptying the Recovery (Lower) Tank
An automatic suction shut-o is built into the recovery tank to prevent the tank from over owing. When the
shuto activates, the cleaner will not pick up debris and the sound of the motor will change. The recovery tank
is full and must be emptied.
Turn cleaner o and disconnect from electrical outlet.
Although not necessary for satisfactory performance, it is recommended that the recovery tank be emptied after
dry vacuuming and before wet operation. Check the solution tank also. It may need to be re lled at this time.
FIG. 4/10
To remove tank, press down
on release button (A) and
pull tank straight out.
Picking Up Spills
Your cleaner may also be used to pick up small liquid spills (max 5mm in depth) on non-carpeted oors.
Turn Mode selector dial to the WET PICKUP position and release the trigger. Continue to move cleaner over
the area to pick up the spill.
IMPORTANT: Do not use the cleaner to pick up ammable or combustible liquids or chemicals. Do not use
the cleaner to pick up detergents that contain solvent based ingredients.
7
FIG. 4/11
Remove tank lid (A).
Empty tank.
Vax Service line:
AU: 1300 361 505
NZ: 0800 800 900
Advertisement
Table of Contents
