Cisco 6000 series Configuration Manual page 19

Chapter 3 Viewing Live Video
Table 3-1
Control
Full Screen check
box
Restore button
Save Settings button
Focus/Zoom
Note
Up Arrow toggle
button
Down Arrow toggle
button
Focus/Zoom controls
Note
Zoom slider
Focus slider
Auto Focus button
OL-28691-01
Camera Video & Control Window Controls (continued)
Description
Becomes available when you check the Enable Motion Detection check box.
Check the Full Screen check box to cause the IP camera to examine the entire
video field for activity.
You can configure the following items for this video field:
Sensitivity—Designates the relative amount of activity that the IP camera
•
must detect in the area before it generates an alert. A lower value means
that more, or faster, activity is required to trigger an alert. A higher value
means that less, or slower, activity is required. The default value is 80.
Threshold—Designates the percentage of pixels that the IP camera must
•
identify as changed in the area before it generates an alert. The camera
monitors for pixel changes at the defined sensitivity level. The default
threshold value is 10.
To configure sensitivity or threshold, right-click anywhere in the video field
border and then drag the Sensitivity and Threshold sliders to the desired
values. Alternatively, enter a value from 1 through 100 for an option and press
the Enter key. To reset the sensitivity and threshold to their default values of
50, click Restore.
Deselects all areas in the video field that you have selected for motion
detection monitoring.
Save the current motion detection configuration.
The Focus/Zoom feature is available only on the Cisco Video Surveillance 6020 IP camera.
Click the Up Arrow to display the focus/zoom controls. The button changes to
the Down Arrow button.
Click the Down Arrow button to hide the focus/zoom controls. The button
changes to the Up Arrow button.
These controls appear when you click the Up Arrow in the Focus/Zoom area.
To control the field of view zoom factor, drag the slider left to zoom out
(wide), or drag the slider to the right to zoom in (telephoto).
To control the field of view focus, drag the slider left to focus on near objects,
or drag the slider to the right to focus on far objects.
Click to automatically focus the IP camera for the selected zoom.
Cisco Video Surveillance 6000 Series IP Camera Configuration Guide, Release 1.1.2
3-5