Download  Print this page
   

Advertisement

Camera Installation

This chapter provides information and instructions for installing the Cisco Video Surveillance
6000P IP Camera, and includes the following topics:

Installation Guidelines

This section describes how to install the IP camera. Before installing, review these guidelines:

Warnings Before Installation

OL-28118-01
Installation Guidelines, page 2-1
Warnings Before Installation, page 2-1
Installing the IP Camera, page 2-4
The IP camera requires a network cable and a connection to a standard 10/100BaseT router or
switch. To power the IP camera with Power over Ethernet (PoE), a switch must be 802.3af
compliant.
If you are using the IP camera on a network connection that does not provide PoE, you must use a
Cisco 12 VDC power adapter (Cisco part number CIVS-PWRPAC-12V) or a third-party 24 VAC
power adapter.
If you are using an input device, output device, or pan/tilt control device, you must configure
additional settings after installing and performing the initial set up of the IP camera before the
external device can fully operate. For detailed information about these settings, see the Cisco Video
Surveillance 6000 Series IP Camera Configuration Guide.
If you do not connect an external device (input, output, or pan/tilt control) when you perform the
following installation procedure, you can install any of these devices later.
Power off the Network Camera as soon as
smoke or unusual odors are detected.
Contact your distributor in the event of this
happening.
C H A P T E R
Keep the Network Camera away from
water. If the Network Camera becomes wet,
power off immediately.
Contact your distributor in the event of this
happening.
Cisco Video Surveillance 6000P IP Camera Installation Guide
2
2-1

Advertisement

Table of Contents

   Related Manuals for Cisco 6000

   Summary of Contents for Cisco 6000

  • Page 1: Camera Installation

    • additional settings after installing and performing the initial set up of the IP camera before the external device can fully operate. For detailed information about these settings, see the Cisco Video Surveillance 6000 Series IP Camera Configuration Guide. •...
  • Page 2 Do not place the Network Camera in high direct sunlight. humidity environments. Do not place the Network Camera on Do not touch the Network Camera during a • • unsteady surfaces. lightning storm. Cisco Video Surveillance 6000P IP Camera Installation Guide OL-28118-01...
  • Page 3 Warning or an IEC60950 compliant limited power source. Statement 353 Caution Inline power circuits provide current through the communication cable. Use the Cisco provided cable or a minimum 24AWG communication cable. Note The power adapter that you use with the IP camera must provide power that is within +/–10% of the required power.
  • Page 4: Installing The Ip Camera

    Chapter 2 Camera Installation Installing the IP Camera Installing the IP Camera To install the Cisco Video Surveillance 6000P IP Camera, perform the following steps: Procedure Turn the lens clockwise into the lens opening until it stops (see Figure 2-1). If necessary, turn it Step 1 counterclockwise slowly until it gets the best attitude.
  • Page 5 • The secondary video stream is enabled. • We recommend that you disable analog video after installation. To disable analog video, see the Cisco Note Video Surveillance 6000 Series IP Camera Configuration Guide. After you install the IP camera, follow the instructions in Chapter 3, “Performing the Initial Setup of the...
  • Page 6 Chapter 2 Camera Installation Installing the IP Camera Cisco Video Surveillance 6000P IP Camera Installation Guide OL-28118-01...

This manual is also suitable for:

6000p

Comments to this Manuals

Symbols: 0
Latest comments: