Cisco 6000 series Configuration Manual page 60

Local Log Window
Table 7-3 Log Messages
Message Name
AUTHORIZATION_FAILED
CODEC_LOST
CONFIG_SAVE_FAILED
CONFIG_SAVED
CONFIG_UPLOAD_FAILED
CONFIG_UPLOADED
DEFAULTS_FAILED
DEFAULTS_RESTORED
DEVICE_REBOOT_AUTO
DEVICE_REBOOT_MANUAL
DHCP_LEASE
DSP_ENCODING_HALTED
EMAIL_TRIGGERED
ETH_BER
ETH_SIGNAL_DEGRADE
FRAMES_DROPPED
FW_UPGRADE_FAILED
FW_UPGRADED
Cisco Video Surveillance 6000 Series IP Camera Configuration Guide, Release 1.1.2
7-6
Description that Appears in Log File
Unauthorized address <IP address or
hostname> attempted to access camera.
Connection to Codec/Sensor module
was lost. Internal module is either down
or not responding.
Saving configuration to user <user>
<IP address or hostname> failed.
Configuration saved by user <user>
<IP address or hostname>.
Uploading configuration failed from
user <user> <IP address or hostname>.
Configuration uploaded from user
<user> <IP address or hostname>.
Restoring factory defaults failed for
user <user> <IP address or hostname>.
Factory defaults restored successfully
by user <user> <IP address or
hostname>.
Device rebooted.
Device was rebooted manually by user
<user> <IP address or hostname>.
DHCP lease renewal was successful.
The Codec/Sensor module's DSP
encoding was halted. Either the analog
image signal from the sensor has been
lost, or an internal encoding error has
occurred.
Event triggered: email sent to <e-mail
address>.
Bit Error Rate (BER) exceeded
specified threshold of <threshold>.
Ethernet signal degrading.
Output frame rate does not match the
camera's configured frame rate.
Upgrading firmware failed from user
<user> <IP address or hostname>.
Firmware upgraded successfully from
user <user> <IP address or hostname>.
Chapter 7
Explanation
An attempt was made to access the IP
camera by using invalid user
credentials from an IP address that has
been configured for no access.
The IP camera codec/sensor module is
not responding.
A user attempt to save the IP camera
configuration failed.
The IP camera configuration was saved
by a user.
A user attempt to import the IP camera
configuration failed.
The IP camera configuration was
imported by a user.
An attempt to reset the IP camera to its
factory default configuration failed.
The IP camera was reset to its factory
default configuration.
The IP camera rebooted automatically. 5
The IP camera was rebooted by a user. 5
The IP camera renewed its DHCP
lease.
The DSP of the IP camera codec/sensor
module DSP stopped encoding. The
analog image signal from the sensor
may be lost or an internal encoding
error may have occurred.
An event occurred and e-mail
notification of the event was sent.
The bit error rate (BER) exceeded the
specified threshold.
The IP camera detected a degrading
Ethernet signal.
The IP camera is sending video at a
frame rate that does not match the
configured frame rate.
An attempt to upgrade the IP camera
firmware failed.
The IP camera firmware was updated.
Log Configuration
Severity
3
4
3
5
3
5
3
5
6
2
5
4
4
3
0
5
OL-28691-01