Mount Installation - CHIEF KWP-110 Installation Instructions Manual

Installation Instructions

MOUNT INSTALLATION

INSTALLATION TO WALL
1. Verify that you have the following parts:
Item Description
10 MOUNT, Wall, K-Series
20 BRACKET, Wall
30 SCREW, Hex Head Lag, 1/4" x 2-1/2"
(ALL EXCEPT KSA-1015/-1016)
40 SCREW, Hex Head Lag, 3/8" x 3"
(KSA-1015/-1016 ONLY)
50 WASHER, Flat Machine Screw, 1/4"
(ALL EXCEPT KSA-1015/-1016)
2. Determine location for mount keeping in mind display
size, extension, height adjustment (if applicable), and
pitch/roll requirements. Bracket (20) MUST be
installed into wood stud.
3. Using bracket (20) as a template, drill two pilot holes
through top and bottom holes of bracket (20) into wall
structure (See Figure 1):
• All Except KSA-1015/-1016: Use 1/8" drill bit
• KSA-1015/-1016 ONLY: Use 1/4" drill bit
20
50
30
40
All except
KSA-1015/-1016
Figure 1: Install Wall Bracket
4. Install bracket (20) (See Figure 1):
• All Except KSA-1015/-1016:
Using 7/16" wrench, install screws (30) through
washers (50), plate (20), and drywall into wood
stud. Ensure bracket (20) is vertical, then tighten
screws (30).
• KSA-1015/-1016 ONLY:
Using 9/16" wrench, install screws (40) through
plate (20) and drywall into wood stud. Tighten
screws (40).
IMPORTANT ! : Overtightening screws (30 or 40, as
applicable) may cause bracket (20) to compress into soft
wall surface, resulting in difficult mount installation or
improper engaging of set screw in step 6.
Qty
1
1
2
2
2
20
KSA-1015/-1016
IMPORTANT ! : IF you will be installing a SINGLE
display with RECESSED mounting holes, then proceed
to "DISPLAY INSTALLATION" before continuing with this
mount installation procedure.
5. Insert top of mount (10) over lip on top of bracket (20)
(See Figure 2). Swing mount (10) down flush against
wall.
NOTE: KWS-110 shown; other wall mounts similar.
Figure 2: Install Wall Mount
6. Tighten set screw using 5/32" hex key (See Figure 3).
Ensure set screw engages back side of bracket (20)
to properly secure mount.
20
Set Screw
NOTE: KWS-110 shown; other wall mounts similar.
Figure 3: Tighten Set Screw
7. Proceed to "CABLE MANAGEMENT" (for SINGLE
display with RECESSED mounting holes), or to
"DISPLAY INSTALLATION" (for all other display
configurations).
Model: K-Series
10
20
5