Maintenance - Clarke Metalworker CL430 Operating & Maintenance Manual

MAINTENANCE

For maximum performance, it is essential that the lathe is properly maintained.
BEFORE USE
Always inspect before use. Any damage should be repaired and maladjustments
rectified. Damage to machined surfaces should be repaired with an oil stone. Test
by hand to ensure smooth operation of all parts before use.
Inject a few drops of oil to the oilways 1 - 8 Fig. 22.
AFTER USE
Remove all swarf from the machine and thoroughly clean all surfaces. If coolant
has been used, ensure it has completely drained from the tray, if used, and all
components are completely dry.
All machined surfaces should be lightly oiled.
Always remove cutting tools, and store in a safe place.
WEEKLY
Leadscrew and Mill Head Spindle should be oiled weekly.
Check oil level on sight glass, 9, Fig.22 and top up where necessary with gear oil.
Remove the filler plug, located directly above the Motor Adjuster, and fill so that
the oil level is midway across the sight glass.
23
Fig.22