Related Manuals for Clarke Jumpstart 910
Summary of Contents for Clarke Jumpstart 910
- Page 1 © 0402 Jumpstart Jumpstart Part Number 6240020 Operating & Maintenance Instructions...
-
Page 2: Important Notice
Air Compressor Max output ............ 16 bar (240psi) PARTS AND SERVICE For Spare Parts and Servicing, please contact your local dealer, or Clarke International on one of the following Numbers: Parts and Service Tel: 020 8988 7400 Parts and Service Fax: 020 8558 3622 or e-mail as follows: Parts: Parts@clarkeinternational.com... -
Page 3: Features And Use
This guarantee does not affect your statutory rights. FEATURES AND USE The Jumpstart 910 is a rechargeable 12 Volt power supply, ideal for starting vehicles in the event of a flat battery. The Jumpstart may also be used to power 12V appliances, such as Mobile Phones, Radios, Electric Coolers etc. -
Page 4: Parts Identification
PARTS IDENTIFICATION Fig. 1 Positive Battery Connection Lead to connect to the positive battery terminal Lamp to provide light for roadside repairs or emergency situations 230/12V Transformer for charging internal battery pack Cigarette Lighter Adaptor for charging internal battery pack Volt Meter to indicate the state of charge of the internal battery Lamp ON/OFF Switch... -
Page 5: Putting To Use
PUTTING TO USE A. Jump Starting ALWAYS carry out the following preliminary checks before connecting the Jumpstart to the battery: • Ensure the vehicle ignition and ALL ancillary equipment - lighting, radio etc., is switched OFF. • Ensure the vehicle battery is rated at 12V and is not damaged in any way. •... -
Page 6: Charging The Battery
2. You should ALWAYS recharge the battery after every use. 3. You should ALWAYS recharge the battery every 3 months 4. You should NEVER leave your Jumpstart 910 battery in a state of discharge. Follow the above rules to ensure maximum working life from your Jumpstart battery Two means of charging the battery are provided. -
Page 7: Maintenance
..using the 12 Volt Adapter Plug the small adapter into the socket at the front of the unit, then the cigarette lighter adapter into the receptacle on the vehicle and start the engine. The red LED will illuminate to denote charging is in progress. Continue to charge until the voltmeter registers ‘Battery Charged’...